15. Remove the left OCP NIC 3.0 adapter rail.
16.
Remove all DIMMs.
17.
Allow the existing heatsink to cool.
18.
Remove the heatsink:
CAUTION: To prevent mechanical damage or depositing oil on your hands or other contaminant to the
heatsink contact surface, hold the heatsink only by the edge of its base plate. Do not touch the heatsink fins.
CAUTION: Heatsink screws must be tightened and loosened in alternating sequence. Do not overtighten the
screws as this might damage the system board or the processor socket.
a.
Use a T-20 Torx screwdriver to loosen the captive screws in the sequence specified on the heatsink label.
b.
Lift the heatsink away from the system board.
Removal and replacement procedures
106
To Next Page
Loading...
