Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1. If installed, remove the bezel.
2. Power down the server.
3. Remove all power:
a.
Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5.
Remove the server from the rack.
6.
Remove the inner rack rails.
7. Remove the access panel.
8.
Remove the primary riser cage.
9.
If installed,
remove the OCP NIC 3.0 adapter.
10.
Remove the left OCP NIC 30 adapter rail.
11. To remove the right OCP rail:
a. Remove the system board.
b. Remove the rail.
Removal and replacement procedures
87
To Next Page
Loading...
