HPE StoreVirtual 3200

Number Cable
6 Power supply
7 Power supply
12. Remove the eight drive cage retaining screws. There are four to each side.
NOTE:
Depending on whether the drive cage is for LFF or SFF drives, the screws are in slightly
different locations.
13. Slide the drive cage toward the front of the enclosure and lift free of the enclosure.
14. Remove the two screws attaching the back plane to the drive cage.
15. Slide the backplane toward the top of the drive cage and lift the backplane off the drive cage.
Installing the enclosure backplane
Procedure
1. Place the replacement backplane on the drive cage and slide toward the bottom of the drive cage on
to the retaining hooks.
2. Install the two backplane screws.
3. Place the drive cage in the enclosure and slide it toward the back of the enclosure. Make sure that
the locating pins in the bottom of the enclosure are all correctly located in the drive cage.
NOTE:
Depending on the specific unit, there are six or eight locating pins.
4. Install the eight drive cage retaining screws.
Installing the enclosure backplane 105