Installing an I/O module
Procedure
1. Slide the replacement I/O module (1) into the enclosure and close the I/O module handle (2).
2. Tighten the captive retainer thumbscrew (3).
3. Reconnect all cables to the I/O module.
Verifying I/O module operation
Procedure
1. Ensure the I/O module is operating properly by checking the status LEDS. For more information, see
"Related reference".
2. Verify that the firmware versions of the I/O module match from the hardware report in the StoreVirtual
Management Console.
More information
Storage controller enclosure controller module status LEDs on page 17
Replacing a power supply module
Installing an I/O module 95
To Next Page
Loading...
