HPE StoreVirtual 3200

Verifying power supply failure
Procedure
Before replacing a power supply, check the power supply status LED to ensure that the power supply has
failed. For the location of the power supply LEDs, see HPE StoreVirtual 3200 drive enclosure on page
12. For information on interpreting the status, see "Related reference".
More information
Status LED descriptions on page 15
Removing a power supply
Procedure
1. Remove the power cable from the power supply to be replaced.
2. Press the latch (1) and slide the power supply module out of the enclosure (2).
96 Verifying power supply failure