Controller with a 1G GbE card
1. Option card 1G ports
2. Built-in 1G ports
All four 1G ports are bonded and share IPv4 address settings in the same subnet.
Controller with a 10GbE card
1. Option card 10GbE ports
2. Built-in 1G ports
On a 10GbE system, only the 10GbE interfaces are bonded in the Configuration setup. The 1GbE ports
can be put in a separate bond later. The 10GbE and 1GbE interfaces must be on different subnets but
can be used simultaneously by assigning different traffic types to the bonds.
Controller with a 10GBase-T card
46 Managing the network
To Next Page
Loading...
