Function Key Features and Settings
155
3. Press and key to select the zero touch
4. Press or Save soft key to save the configuration
To configure the zero touch via web interface:
1. Click Function keys →Line Key.
2. Select the desired Key and select zero touch in the Type.
3. Click the button to save the configuration.
To use the zero touch feature on the user interface:
1. Press the zero touch key when the IP Phone is idle.
2. The IP Phone will enter the WAN Port interface; you can change the WAN Type by pressing
the Navigation keys.
3. Press the Next softkey to enter Network interface, then you can configure some information.
4. Press the Next softkey again, you can configure auto provision information.
5. When you finish the setting, you can press the OK to accept the changes.
Note：
This feature is not available on all servers. For more information, contact your system
administrator.
Multicast Paging
You can use multicast paging to quickly and easily forward out time sensitive announcements to
people within the multicast group. You can configure a multicast paging key or a paging list key
on the phone, which allows you to send a Real Time Transport Protocol (RTP) stream to the
pre-configured multicast address/addresses without involving SIP signaling. You can configure the
phone to receive an RTP stream from pre-configured multicast listening address/addresses without
involving SIP signaling. You can specify up to 10 multicast listening addresses.
To Next Page
Loading...
