Function Key Features and Settings
157
precedence over all incoming multicast paging calls.
Valid values in the Paging Barge field:
1 to 10: Define the priority of the active call, 1 with the highest priority, 10 with the lowest.
Disabled: The voice call in progress will take precedence over all incoming paging calls.
Paging Priority Active
The paging priority active parameter decides how the phone handles incoming multicast paging
calls when there is already a multicast paging call on the phone. If enabled, the phone will ignore
incoming multicast paging calls with lower priorities, otherwise, the phone will answer incoming
multicast paging calls automatically and place the previous multicast paging call on hold. If
disabled, the phone will automatically ignore all incoming multicast paging calls.
Multicast Codec：
You can only configure the codec by web interface.
To configure multicast codec key via web interface
1. Click Directory ->Multicast Paging：
2. Select the desired codec from the pull-down list of Multicast Codec
3. Click the button to save the configuration.
To configure multicast listening addresses via web interface:
1. Click Directory->Multicast paging。
2. Select the desired value from the pull-down list of Paging Barge.
3. Select the desired value from the pull-down list of Paging Priority Active.
4. Enter the multicast IP address/addresses and port number (e.g., 224.5.6.20:2000) which the
phone listens to for incoming RTP multicast in the Listening Address field.
5. Enter the label in the Label field.
6. Click button to save the configuration.
To Next Page
Loading...
