Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the rack number and chassis number of the server to be removed, and label its
panel to prevent misoperations.
Step 3 Power off the 5288 V3. For details, see 4.2 Powering Off the Server.
Step 4 Remove all external cables such as power and network cables.
Step 5 Remove the 5288 V3 and put it on an ESD desktop. For details, see 3.6 Removing the
Server.
Step 6 Remove the chassis cover. For details, see 7.11 Removing the Chassis Cover.
Step 7 Remove full-height full-length riser cards if they are installed. For details, see 7.19 Removing
the Riser Card.
Step 8 Remove the supercapacitor if it is installed. For details, see 7.33 Removing the
Supercapacitor (RAID Controller Card).
Step 9 Determine the position for installing the RAID controller card. See Figure 7-57.
Figure 7-57 Position of the RAID controller card
Step 10 Hold down the latches on the cables to the RAID controller card, and remove the cables from
the RAID controller card. For details, see 2.7 Internal Cabling.
Step 11 Loosen the screws on the RAID controller card. See step (1) in Figure 7-58.
5288 V3 Server
User Guide
7 Replacing Parts
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 171
To Next Page
Loading...
