Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Remove the SD card board to be replaced. For details, see 7.49 Removing an SD Card
Board.
Step 3 Take the spare SD card board out of the ESD bag.
Step 4 (Optional) If SD card 2 needs to be installed, install it first. For details, see 7.48 Installing an
SD Card.
NOTE
After the SD card board is replaced, the positions of SD card 1 and SD card 2 cannot be reversed. SD
card 1 is above the SD card board, and SD card 2 is below the SD card board.
Step 5 Align the SD card board connector with the port on the mainboard, and press the SD card
board downwards to secure it to the mainboard. See step (1) in Figure 7-105.
Figure 7-105 Installing an SD card board
Step 6 Tighten the two screws. See step (2) in Figure 7-105.
Step 7 Install SD card 1. For details, see 7.48 Installing an SD Card.
NOTE
After the SD card board is replaced, data in the original SD card can be retained and RAID takes some
time to rebuild. Please wait.
During RAID rebuilding, you can view the progress and status on the iBMC event log page.
5288 V3 Server
User Guide
7 Replacing Parts
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 221
To Next Page
Loading...
