Figure 2-13 Signal cables to the front hard disk backplane
N
o.
Description BOM Number
1 Signal cable for connecting the front hard disk
backplane (J32) to the rear hard disk backplane
marked 7 (J24)
04051053
2 SAS HD cable (Port A-Port A) for connecting the
front hard disk backplane to the RAID controller card
on the mainboard
04051018
3 SAS HD cable (Port B-Port B) for connecting the
front hard disk backplane to the RAID controller card
on the mainboard
04051018
4 SAS HD cable (one-into-two cable) for connecting the
front hard disk backplane (J31 REAR PORT) to the
rear 2-bay hard disk backplane (J3)
NOTE
This cable is a Y-shaped cable. The end with one connector
is connected to the front drive backplane, and the other end
is connected to the rear drive backplane. The cable must be
routed along the chassis wall on the same side with the
PSUs. The cable length limit prevents this cable from being
connected to the other rear drive backplane.
If a one-to-two SAS cable is incorrectly connected, a disk
error alarm is generated on the iBMC WebUI.
04051060
5 Signal cable for connecting the front hard disk
backplane (J35) to the rear hard disk backplane
marked 8 (J24)
04051053
6 Signal cable for connecting the front hard disk
backplane (J1 MAIN BOARD) to the mainboard
(J1003)
04051340
5288 V3 Server
User Guide
2 Product Overview
Issue 26 (2018-11-19) Copyright © Huawei Technologies Co., Ltd. 33
To Next Page
Loading...
