Exercise caution because the device is still energized after it is shut down on the
controller home screen.
Step 2 Open the rear door and remove the air lter.
Step 3 Remove the cable terminals from the RS485_IN and RS485_OUT ports on the T/H
sensor, as shown in Figure 1.
Step 4 Pull out the T/H sensor in the direction shown in Figure 2.
Figure 5-58 Removing a T/H sensor
Before installing the new T/H sensor, check that its DIP switch settings are consistent with the
DIP switch settings of the old T/H sensor.
Step 5 Connect cable terminals to RS485_IN and RS485_OUT ports, and install a new T/H
sensor in the position where the original T/H sensor was installed.
FusionModule2000 Smart Modular Data Center
Maintenance Guide (Fusion Module Actuator) 5 Parts Replacement
Issue 01 (2020-12-25) Copyright © Huawei Technologies Co., Ltd. 106
To Next Page
Loading...
