Huawei TE20 - Unpairing a Remote Control; Using the Simulated Remote Control

TE20 Videoconferencing Endpoint
Administrator Guide
2 Getting Started
Issue 01 (2016-09-01)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7

On the main menu, press the button on the remote control, switch to , and press
the button on the remote control to enter the Call screen.
This screen provides two options: Call and Call History.

On the main menu screen, you can go between System Settings, AirPresence, Call,
Camera Control and Do Not Disturb using the arrow buttons or click wheel.
− If you want to access the System Settings, enter the password (default: 12345678).
− If no administrator password is set beforehand, you can access any module of the
remote control UI.
2.1.4 Unpairing a Remote Control
If you want to use a TE10-paired remote control to operate a TE20, unpair the remote control
from its paired TE10 first.
The TE10 remote control can be used by the TE20, and vice versa. If you want to use a
TE10-paired remote control to operate a TE20, unpair the remote control from its paired TE10
first.
It is recommended that you operate the TE10 or TE20 with the remote control that comes with it.
Press and hold the and buttons simultaneously for 3s. The unpairing succeeds
when you see the remote control indicator on for 1s.
2.1.5 Using the Simulated Remote Control
You can invoke the simulated remote control on the web interface and click on it to control
your endpoint.
On the web interface, choose Device Control > Use Remote Control to invoke the simulated
remote control show in Figure 2-3.