TE20 Videoconferencing Endpoint
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Allows the user to submit the log out application.
When you have logged in to the web interface, you can click Exit in the upper right
corner. The login interface is displayed.
Allows at most 10 users to use the same or different accounts to log in to the web
interface concurrently.
If the number of user attempts to log in to the endpoint web interface reaches a predefined
number, the user account will be locked and cannot be used for login until the locking
duration ends. On the web interface, choose System Settings > Security > Web Login, and
set Maximum login attempts and Lock time.
10.2.6 SSH Access Control
During remote access and data transmission, SSH commands can be run to create an
encrypted channel between the application layer and client.
Enabling SSH or Telnet
Telnet is an insecure communication protocol. You are advised to disable Telnet login. To
enable Telnet login, choose System Settings > Security > SSH/Telnet on the web interface to
enable SSH or Telnet.
User Login
Following describes SSH access control methods using the PuTTY as an example.
PuTTY is a login application for remote login across different platforms. It can be obtained from Huawei
Unified Communications and Collaboration (UC&C) Security Center by Huawei technical support or
downloaded from the Internet. Use PuTTY 0.63 or a later version.
Step 1 Run PuTTY on your computer.
The PuTTY Configuration dialog box is displayed, as shown in Figure 10-2.
To Next Page
Loading...
