Huawei TE20 - Restoring Systems to Default Settings

TE20 Videoconferencing Endpoint
Administrator Guide
10 Security Maintenance
Issue 01 (2016-09-01)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
86
Wi-Fi Hotspot
Name
Default Setting
Description
Remarks
TEX0_wifi_ap
The required
password varies
depending on your
setting of
Encryption mode.
If you set Identity
authentication
mode to OPEN and
Encryption mode
to NONE, the
Wi-Fi network
provided is open to
everyone. In other
circumstances, the
default password is
Change_Me. To
ensure account
security, do not set
Identity
authentication
mode to OPEN.
The devices, such
as tablets, and
PCs, can access a
Wi-Fi network by
connecting to the
endpoint.
On the web interface,
change SSID Number
and Password of the
Wi-Fi hotspot as follows:
Choose System
Settings > Network >
Wi-Fi Settings, enable
Wi-Fi Hotspot, and set
SSID Number and
Password.
If you set Identity authentication mode to OPEN or WPA-PSK, the authentication or encryption
mode may result in security risks. Therefore, WPA2-PSK is recommended.
Wi-Fi Hotspot Whitelist
To enhance connection security, configure the Wi-Fi hotspot whitelist.
Before configuring the Wi-Fi hotspot whitelist, ensure that Wi-Fi hotspots have been enabled.
Configure the Wi-Fi hotspot whitelist as follows:
1. Choose System Settings > Network > Wi-Fi Settings, and click the Wi-Fi hotspot tab.
2. Click Whitelist.
3. Select Enable.
You can modify the whitelist only after selecting Enable here.
4. Click Add and add MAC address.
5. Click OK. The settings take effect immediately.
10.2.2 Restoring Systems to Default Settings
If you forget the passwords, restore the system (including the passwords) to its default
settings.
When the endpoint is running, press and hold the RST button for 10s to restore to factory
defaults. After you press and hold the RST button for 3s, the system will prompt you that
your endpoint will restore to factory defaults if you press and hold this button for 10s.