Huawei TE20 - Enabling FTPS; Configuring an FTPS Server

TE20 Videoconferencing Endpoint
Administrator Guide
10 Security Maintenance
Issue 01 (2016-09-01)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
91
Step 2 On the Logs page, click Export.
Step 3 Click Save in the displayed dialog box.
Step 4 Choose the folder to save the logs and click Save.
Step 5 Open the exported logs using the Internet Explorer.
----End
10.2.8 Enabling FTPS
The endpoint supports File Transfer Protocol over SSL (FTPS) and File Transfer Protocol
(FTP). To improve communication security, enable FTPS. After the network address book is
enabled, the endpoint enables FTPS by default.
On the web interface, choose System Settings > Network > Address Book > FTP address
book, and enable or disable FTPS.
10.2.9 Configuring an FTPS Server
FTPS is an extension of the commonly used FTP to support the SSL. The FTPS server
ensures the security of the endpoint network address book.
To configure the network address book after the FTPS client is configured, see the 6 Address Book
Management.
Following uses the FileZilla server as an example to describe how to configure an FTPS
server.
Step 1 Set the IP address of the computer on which the FTPS server (for example, FileZilla server) is
to be installed. Ensure that the IP addresses of the computer and endpoint are in the same
network segment.
Step 2 Run the FTPS server installer (for example, FileZilla_Server-0_9_41.exe) to install the FTPS
server on the computer.
Step 3 Double-click to run the FTPS server. Click OK in the displayed dialog box, as shown
in Figure 10-3.