Huawei TE20 - Page 46

TE20 Videoconferencing Endpoint
Administrator Guide
4 Conference Operations Using the Web Interface
Issue 01 (2016-09-01)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
38
Parameter
Description
Setting
letters, and special characters,
such as @ # %.
User name
Password
Specify the user name and password that
your endpoint uses to register with the
IMS server.
The password you set here must be the
same as that set on the IMS server
beforehand.
User name example:
+8675584221069@huawei.co
m
Obtain the value of this
parameter from the IMS server
administrator.
Server type
Specifies the SIP server type.

Standard: Select this option if your
endpoint registers with other SIP
servers.

CISCO VCS: Select this option if
your endpoint registers with the Cisco
TelePresence Video Communication
Server (VCS).
Set this parameter to Standard.
Transmissio
n type
Specifies the protocol used for SIP
signaling transmission.

TCP: Use the Transmission Control
Protocol (TCP) to implement
transmission reliability.

UDP: Use the User Datagram
Protocol (UDP) to implement
transmission with reduced latency.

TLS: Use Transport Layer Security
(TLS) to implement transmission
security. With this option selected, a
root certificate must be imported
when your endpoint registers with a
SIP server. For details, see 10.2.10
Managing Certificates. The call rate
may be compromised if this option is
selected.
Set this parameter to UDP.
The IMS network only supports
UDP transmission.
SSL version
Specifies the encryption protocol used by
SIP calls. The value can be TLS 1.0 or
TLS 1.1.
NOTE
This parameter is available only after
Transmission type is set to TLS.
The default value is TLS 1.1.
BFCP
Transmissio
n type
Specifies the protocol used for BFCP
signaling transmission.

Auto: Automatically select a protocol
based on the BFCP tranmission type
supported by the remote site.

TCP: Use the Transmission Control
Protocol (TCP) to implement
The default value is UDP.