Huawei TE20 - Page 66

TE20 Videoconferencing Endpoint
Administrator Guide
6 Address Book Management
Issue 01 (2016-09-01)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
58
Parameter
Description
Setting
Type
Specifies the type of the line the site uses to
access the videoconferencing network.

If you select IP, your endpoint will use the
protocol set for Preferred IP protocol to
call the site.

If you set Category to CT site, the
available value for Type is SIP.
The default value is
H.323.
Rate
Specifies the data transmission rate of the line
selected for the remote endpoint.
The supported data transmission rates vary
depending on the type of the site you want to
call.
Select the highest
available data
transmission rate.
Country/Reg
ion code
Specifies the country or area where the site is
located.
This parameter is available only for integrated
services digital network (ISDN) and public
switched telephone network (PSTN) sites.
No default value is set for
this parameter.
Area code
Specifies the area code for the site.
This parameter is available only for ISDN and
PSTN sites.
No default value is set for
this parameter.
Number
Specifies the site number used to place calls
between sites.
This parameter is unavailable for an ISDN
site.

IP, E1, 4E1, ISDN, and H.323 phone site
numbers are allocated by the
videoconferencing service provider.

PSTN site numbers are telephone numbers.
No default value is set for
this parameter.
IP address
Specifies the IP address of the site.
NOTE

The IP address parameter is unavailable for a
Ordinary site whose Type is ISDN, PSTN, E1,
or 4E1.

The IP address parameter is unavailable for a
Telepresence site.

This parameter is unavailable if you set
Category to CT site.
No default value is set for
this parameter.
URI
Specifies the uniform resource identifier (URI)
of the site, for example, abcd@huawei.com.
NOTE
This parameter is available only when Type is set to
IP, H.323, or SIP.
No default value is set for
this parameter.
Center codec
number
Center codec
These parameters are available only after
Category is set to Telepresence site.
These parameters specify the numbers and IP
No default values are set
for these parameters.