8018653 1.1 About this manual • xi
About this manual
The Base Station Controller Installation and Maintenance Manual
contains the information necessary to install and maintain the base
station controllers used in the GMH 2000 digital cellular communica-
tions network. This document describes installing the base station
controller (BSC) racks only; all other hardware must already be installed
(refer to the GMH 2000 Base Station Controller Site Preparation
Specifications for more information).
Audience This manual is written for the GMH 2000-trained technician. BSC
equipment is complex and precludes service by untrained personnel.
Structure This manual contains the following chapters and appendices:
• Chapter 1 provides a general description of the GMH 2000 system.
• Chapter 2 contains the BSC installation procedures.
• Chapter 3 describes activating and deactivating the BSC.
• Chapter 4 covers troubleshooting.
• Chapter 5 covers periodic maintenance, describes measures for
protecting personnel and equipment from electrostatic discharge,
and contains the procedures for replacing failed equipment.
•Appendix A lists the abbreviations and acronyms used in this
manual.
Assumptions Installation and maintenance procedures in this manual are based on the
following assumptions:
•All procedures will be performed by qualified service personnel
who are familiar with the GMH 2000 architecture and configura-
tion, BSC hardware elements, and terminology.
•Personnel responsible for equipment installation and maintenance
will have access to the customer’s site configuration documenta-
tion. This documentation provides information needed to install
and to configure the BSC at a particular site for operation within
the digital cellular network.
To Next Page
Loading...
Need help?
General