Gas Connect Consoles
XPR170 Field Service Bulletin 810410 93
16. Install the 2 CAN cables on the mixer module. Use your fingers to tighten these connections.
Do not use tools. Tools can damage these connectors. Do not cross-thread the CAN cable
connectors. If these connections are cross-threaded, they are not easy to remove.
17. Install the manifold-side panel on the gas connect console. Make sure to not pinch the wires.
Refer to Gas connect console panels on page 100.
18. Use the cable tie to hold the CAN cables in position.
19. Supply gas pressure to the cutting system.
To Next Page
Loading...
