Step 1322-27
Is the error class recorded in “Step 1322-6” on page 100 AIX?
No Go to “Step 1322-33”.
Yes Go to “Step 1322-28”.
Step 1322-28
Perform the following steps for each entry in the list of all partition(s) you recorded in “Step 1322-11” on
page 101, except the partition you were using to debug the original problem.
Step 1322-29
From the HMC virtual terminal window of a partition in the list of all partitions, type diag at the AIX
command prompt.
Step 1322-30
1. When the diagnostic operating instructions are displayed, press Enter.
2. Select the Task Selection option.
Note: If the terminal type is not defined, you are prompted to define it before you can proceed.
3. Select the Log Repair option.
4. Select the resource associated with the repair action. If the repair action was reseating a cable or
adapter, select the resource associated with that repair action. If the resource associated with your
repair action is not displayed on the Resource List, select sysplanar0.
5. Click commit after you have made your selection.
Step 1322-31
Exit from diagnostics in this partition and return to the AIX prompt.
Step 1322-32
Have all the partitions in the list of all partition(s) you recorded in “Step 1322-11” on page 101 been
processed?
No Go to “Step 1322-28” to process the next partition in the list you recorded in “Step 1322-11” on
page 101.
Yes Go to “Step 1322-33”.
Step 1322-33
Have all the serviceable events recorded in “Step 1322-4” on page 100 been processed?
No Go to “Step 1322-5” on page 100 and process the next service action event in the list of
serviceable events recorded in “Step 1322-4” on page 100.
Yes Go to “Step 1322-34” on page 104.
Chapter 3. Maintenance Analysis Procedures (MAPs) 103
To Next Page
Loading...
Need help?
General