IBM pSeries 630 6C4 User Manual

Checkpoint Description Action/
Possible Failing FRU
910F Test and initialize main storage (system
memory)
See note 1 on page 167.
9110 Free IPL LIDs See note 1 on page 167.
9111 Load run-time LIDS See note 1 on page 167.
9112 Load dump LIDs See note 1 on page 167.
9113 Enable attention See note 1 on page 167.
9114 Enable function 22 See note 1 on page 167.
9115 Load system IPL program See note 1 on page 167.
9116 Load system data areas (NACA/PACA) See note 1 on page 167.
9117 Start system IPL program See note 1 on page 167.
9119 Waiting for VPD collection to complete See note 1 on page 167.
9184 Firmware image being loaded into service
processor’s control storage during firmware
update.
1. Remove, then reapply power to the
system. If the service processor enters
recovery mode, (indicated by A1FD
0000 in the display), attempt to update
the firmware again in recovery mode. If
the service processor comes up to the
OK prompt, try again to update the
firmware using the service processor
menus.
2. Call service support.
91C4 Flash update pending, either a firmware
update or hypervisor dump.
Note: This checkpoint may be displayed
during the firmware update process. The
checkpoint may be displayed for a long
period of time during the process. If
process does not complete, the system
may be hung.
See note 1 on page 167.
91FF Control being handed to system processor
from service processor
See note 1 on page 167.
9200 Scan interface BATs See note 1 on page 167.
9300 Logic BIST See note 1 on page 167.
9301 Scanned ABIST See note 1 on page 167.
9302 Dedicated ABIST See note 1 on page 167.
9303 Dedicated ABIST array fuse repair
calculation
See note 1 on page 167.
9380 Built-in-self-test (BIST) See note 2 on page 167.
9400 Service processor is requesting system
flush
See note 1 on page 167.
9410 Service processor is issuing request to start
instruction execution
See note 1 on page 167.
9411 Service processor is issuing request to stop
instruction execution
See note 1 on page 167.
9420 Service processor is issuing request to start
system clocks
See note 1 on page 167.
9421 Service processor is issuing request to stop
system clocks
See note 1 on page 167.
164 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide

IBM pSeries 630 6C4 Specifications

General

Brand	IBM
Model	pSeries 630 6C4
Category	Server
Language	English