IBM pSeries 630 6C4 - Page 196

Checkpoint Description Action/
Possible Failing FRU
E50D Copy all of the I/O data
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E50E Copy all of the RIO hub information
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E50F Clean up the error registers
1. Check for system firmware updates.
2. Replace the RIO riser card specified by
the location code.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E51F End of I/O configuration
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E520 Set up the RIO architecture registers
1. Check for system firmware updates.
2. Replace the RIO riser card specified by
the location code.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E521 Set up interrupts for the current RIO hub
1. Check for system firmware updates.
2. Replace the RIO riser card specified by
the location code.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E522 Set up miscellaneous registers for the
current RIO hub
1. Check for system firmware updates.
2. Replace the RIO riser card specified by
the location code.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E523 Initialize data structures and enable all RIO
hub ports
1. Check for system firmware updates.
2. Replace the RIO riser card specified by
the location code.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E524 Determine I/O configuration of current RIO
hub
1. Check for system firmware updates.
2. Replace the RIO riser card specified by
the location code.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E525 Set up the ETE of the current RIO hub
1. Check for system firmware updates.
2. Replace the RIO riser card specified by
the location code.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
176 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide