IBM pSeries 630 6C4 - Page 195

Checkpoint Description Action/
Possible Failing FRU
E500 Begin I/O drawer configuration
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E501 Initialize I/O data structures
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E502 Set up I/O data structure pointers
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E503 Initialize location code data structures
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E504 Initialize memory map data structures
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E505 Enable the time base for all RIO hubs
1. Check for system firmware updates.
2. Replace the RIO riser card specified by
the location code.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E506 Reset time base of processors
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E507 RIO hub assignment
1. Check for system firmware updates.
2. Replace the RIO riser card specified by
the location code.
3. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E508 Begin initializing RIO hubs
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E509 Begin configuring EADS
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E50A Check for missing RIO interface chips
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E50B Save RIO hub information
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E50C Copy all of the memory ranges
1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
Chapter 4. Checkpoints 175