Checkpoint Description Action/
Possible Failing FRU
E600 SSA PCI adapter open firmware has run
successfully.
Replace the adapter.
E601 SSA PCI adapter BIST has started but
failed to complete after 4 seconds.
Replace the adapter.
E602 SSA PCI open firmware has started. Replace the adapter.
E603 SSA PCI adapter BIST has completed with
an error.
Replace the adapter.
E604 SSA PCI adapter BIST and subsequent
POSTs have completed successfully.
Replace the adapter.
E605 SSA PCI adapter BIST has completed
successfully but subsequent POSTS have
failed.
Replace the adapter.
E60E SSA PCI open firmware about to exit (no
stack corruption).
Replace the adapter.
E60F SSA PCI open firmware has run
unsuccessfully.
Replace the adapter.
E6FF SSA PCI open firmware about to exit (with
stack corruption).
Replace the adapter.
E700 Create system firmware VPD System firmware may be corrupted.
Reinstall system firmware.
E701 Create memory VPD.
1. Check for system firmware updates.
2. Call for support.
E702 Create processor card VPD.
1. Check for system firmware updates.
2. Call for support.
E703 Create operator panel VPD.
1. Check for system firmware updates.
2. Call for support.
E704 Create CEC VPD.
1. Check for system firmware updates.
2. Call for support.
E705 Create VPD.
1. Check for system firmware updates.
2. Call for support.
E706 Create VPD.
1. Check for system firmware updates.
2. Call for support.
E707 Create system VPD.
1. Check for system firmware updates.
2. Call for support.
E708 Create VPD. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
E709 Create VPD via SPCN.
1. Check for system firmware updates.
2. Call service support.
E70A Create service processor VPD.
1. Check for system firmware updates.
2. Call for support.
E70B Create L3 module VPD
1. Check for system firmware updates.
2. Call service support.
200 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
To Next Page
Loading...
