IBM pSeries 630 6C4 - Page 222

Checkpoint Description Action/
Possible Failing FRU
E853 Start cable ID request process
1. Check the SPCN and RIO cabling to
the I/O subystems.
2. Remove, then reapply power to the
system.
3. Go to “MAP 1542: I/O Problem
Isolation” on page 127.
4. Call service support.
E854 Start collecting cable IDs 1. Check the SPCN and RIO cabling to
the I/O subystems.
2. Remove, then reapply power to the
system.
3. Go to “MAP 1542: I/O Problem
Isolation” on page 127.
4. Call service support.
E855 Start setting RIO link speed 1. Check the SPCN and RIO cabling to
the I/O subystems.
2. Remove, then reapply power to the
system.
3. Go to “MAP 1542: I/O Problem
Isolation” on page 127.
4. Call service support.
E860 Initializing RTAS/power subsystem interface 1. Check for system firmware updates.
2. Call service support.
E861 Initializing RTAS/PCI bus interface 1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
3. Call service support.
E870 Initializing RTAS/logs interface 1. Check for system firmware updates.
2. Call service support.
E871 Initializing RTAS/EEH handling interface 1. Check for system firmware updates.
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 124.
3. Call service support.
E872 Initializing RTAS/error inject interface 1. Check for system firmware updates.
2. Call service support.
E873 Initializing RTAS/error handling interface 1. Check for system firmware updates.
2. Call service support.
E880 Initializing RTAS/debug interface 1. Check for system firmware updates.
2. Call service support.
E881 Initializing RTAS/utility interface 1. Check for system firmware updates.
2. Call service support.
E882 Initializing RTAS/softpatch register interface 1. Check for system firmware updates.
2. Call service support.
E890 Initializing RTAS/hot-plug interface 1. Check for system firmware updates.
2. Call service support.
E8C1 Initializing interface/client interface access 1. Check for system firmware updates.
2. Call service support.
E8D1 Initializing interface/memory access 1. Check for system firmware updates.
2. Call service support.
202 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide