Table 4. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
20D1 0004 Failed to locate service processor device tree
node
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D1 0005 Failed to reboot system
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D1 0006 Failed to reboot a partition
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D1 0007 Failed to set PCI read/write permissions array
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D1 0008 Failed to set PCI read/write permissions array
for slot
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D1 0009 Missing or invalid subsystem serial number
1. Check for system firmware updates. Apply
update if available.
2. If a location code is shown with this error
code, replace the part at that location.
3. Contact your next level of support for
assistance.
Note: The location code identifies the failing
subsystem.
20D1 000A Failed to send boot failed message to service
processor
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D1 000B Failed to reset PCI read/write permissions array
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D1 000C Failed to send LMB-TABLE-INFO mailbox repair
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
20D1 000D Function to get time-of-day failed.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
230 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
To Next Page
Loading...
Need help?
General