Install the Model 6C4 onto a System Rail Assembly (Type 2)
To install the Model 6C4 onto a system rail assembly (type 2), do the following:
1. Using eight M3 rail to system retaining screws, four on each side, mount the inner rails to each side of
the system drawer. Tighten each of the screws with a screwdriver or similar tool.
1
2
3
5
4
6
1 Outer Rail Section 4 M3 Rail to System Retaining Screws
2 Middle Rail Section 5 Safety Latch
3 Inner Rail Section 6 Model 6C4
Note: The safety release latch, located on each inner rail, is mounted onto the side of the system
facing away from the system drawer. See the illustration on page 569.
2. Using three persons, grasp the two handles located on each side of the system drawer, and lift the
system drawer.
3. Insert the inner rails located on the system drawer into the rails mounted in the rack.
Attention: When matching the inner rails to the outer rails, ensure that both rail faceplates glide past
each other. Do not, under any circumstances, force the rails. If the system drawer does not glide freely
into the rack, completely remove the drawer from the outer rails. After the drawer is clear of the outer
rails, reposition the system, then reinsert the inner rails. Repeat this process until the system drawer
glides freely into the rack.
4. Simultaneously press the safety latches, located on each side of the system drawer, and push the
system into the rack.
582 Eserver pSeries 630 Model 6C4 and Model 6E4 Service Guide
To Next Page
Loading...
Need help?
General