4. Chassis mounting brackets
Note: Handles are to be used only for positioning an empty chassis
5. Chassis handles
6. System LEDs
7. Ground point
8. Grid A PSU bays (1, 2, 5, 6, 9, 10, 13, 14)
9. Grid B PSU bays (3, 4, 7, 8, 11, 12, 15, 16)
Note: Handles are to be used only for positioning empty chassis.
Figure 2 on page 6 shows the standard hardware features seen from the rear of the chassis.
Figure 2. SAN768C-6 Chassis Rear View
1. Fan modules - (Three fan modules) 1-3 are numbered left to the right. When the fan modules are
installed, they cover the crossbar fabric switching modules. Only two fan modules are shown in the
figure. One fan module is removed to show the crossbar fabric switching module in the back.
2. Crossbar fabric switching modules - (up to six crossbar fabric switching modules with two modules
behind each fan module). The crossbar fabric switching modules are installed vertically in slots 21
through 26, numbered from left to right, at the back of the chassis behind the fan modules.
3. Fan module handle
6IBM Storage Networking SAN192C-6, SAN384C-6 and SAN768C-6: SAN192C-6, SAN384C-6 and SAN768C-6
Installation, Service, and User Guide
To Next Page
Loading...
Need help?
General