IBM SAN192C-6 - Leds on the 24;10 Port SAN Extension Module; IBM 24;10 Port SAN Extension Module Leds

4. Status LED
5. ID LED
6. Link LEDs
7. Fibre Channel port group. A port group consists of four ports. 16-Gbps ports
8. 10-GIPS port group. A port group consists of four ports.
9. 10-GIPS port group. A port group consists of four ports.
10. 40-GIPS port group. A port group consists of two ports.
Note: The 40-GIPS ports are not supported.
LEDs on the 24/10 Port SAN Extension Module
Table 10 on page 35 describes the LEDs for the 24/10 port SAN Extension module.
LED Status Description
Green All diagnostics pass. The
module is operational (normal
initialization sequence).
Orange One of the following occurs or
occurred:
The module is booting or running
diagnostics (normal initialization
sequence).
An over temperature condition
has occurred. (A minor
temperature threshold has been
exceeded during environmental
monitoring.)
Status
Blinking Red One of the following occurs: The
module is resetting. The switch
has just been powered on or the
module has been hot inserted
during the normal initialization
sequence.
An over temperature condition
has occurred (a major
temperature threshold has been
exceeded during environmental
monitoring). If the module
fails to download the code
and configuration information
successfully during the initial
reset, the LED stays blinking
red; the module does not come
online.
Table 10. IBM 24/10 Port SAN Extension Module LEDs
Chapter 1. Introducing the IBM c-type SAN Directors35