Chapter 3. Installing the IBM c-type SAN Device
This chapter describes how to install the IBM c-type SAN Device chassis and its components, and
includes the following information:
• “Attaching Bottom-Support Rails to a Four-Post Rack” on page 57
• “Attaching Bottom-Support Rails to a Four-Post Rack” on page 57
• “Attaching Bottom-Support Rails to a Two-Post Rack for the SAN192C-6 Director” on page 55
• “Installing the SAN384C-6 or SAN768C-6 Device on a Four-Post Rack or Cabinet” on page 66
• “System Grounding” on page 75
• “Installing, Removing and Verifying Field Replaceable Units” on page 78
• “Installing and Removing a Power Supply” on page 121
• “Installing and Removing Fan Modules” on page 123
Precautions for Installation
Note: Before you install, operate, or service the system, read the IBM Systems Safety Notices for
important safety information.
Warning: IMPORTANT SAFETY INSTRUCTIONS
This warning symbol indicates danger. You are in a situation that could cause physical injury.
Before you work on any equipment, be aware of the hazards involved with electrical circuitry
and be familiar with standard practices for preventing accidents. Use the statement number
provided at the end of each warning to locate its translation in the translated safety warnings that
accompanied this device.
SAVE THESE INSTRUCTIONS
Warning: This unit is intended for installation in restricted access areas. A restricted access area
can be accessed only through the use of a special tool, lock and key, or other means of security.
Warning: Only trained and qualified personnel should be allowed to install, replace, or service
thisequipment.
Warning: A readily accessible two-poled disconnect device must be incorporated in the fixed
wiring.
Preparing for Installation
This section provides the following topics:
• “Unpacking and Inspecting the Switch” on page 54
• “Required Equipment” on page 54
• “Installation Guidelines” on page 55
©
Copyright IBM Corp. 2019, 2021 53
To Next Page
Loading...
Need help?
General