IBM Storwize V7000 - SAS Cable Connectors

Figure 75. Location of secondary expander modules
This task assumes that the following conditions were met:
• The top cover was removed, as described in “Removing the top cover: 2076-92F ” on page 46.
• The secondary expander module was removed, as described in “Removing a secondary expander
module: 2076-92F ” on page 93.
Procedure
1. Slide the expansion enclosure out from the rack, as described in “Removing an expansion enclosure
from a rack: 2076-92F ” on page 83.
2. Identify the secondary expander module to be replaced; Figure 76 on page 68 shows the LEDs on
top of a secondary expander module.
Figure 76. LEDs on a secondary expander module
1 Online indicator
2 Fault indicator
3. Rotate both handles on the new secondary expander module to an open position, as shown in Figure
77 on page 69.
68
Storwize V7000 : Gen3 Quick Installation Guide for MTM 2076-724, 2076-U7B, 2076-12F, 2076-24F, and
2076-92F