IBM Storwize V7000 - Secure Power Cables; Power and SAS Cable Connections on the Back of the Enclosure

About this task
This task assumes that the following conditions are met:
• You removed the PSU, following the procedure described in “Removing a power supply: 2076-92F ” on
page 89.
• You removed the fascia that covers the PSU from the front of the expansion enclosure, as described in
“Removing the fascia: 2076-92F ” on page 74.
• You are aware of the procedures for handling static-sensitive devices.
Procedure
1. Read all safety information.
2. Rotate the handles on the PSU outward, as shown in Figure 81 on page 72.
Figure 81. Preparing to install the power supply
3. Slide the PSU forward into the chassis until it clicks in to place, as shown in Figure 82 on page 73.
72
Storwize V7000 : Gen3 Quick Installation Guide for MTM 2076-724, 2076-U7B, 2076-12F, 2076-24F, and
2076-92F