For more information about the power supply indicators, see â Storwize V7000 2076-92F expansion
enclosure LEDs and indicatorsâ on page 116.
Removing the fascia: 2076-92F
To complete some service tasks, you can remove each component of the fascia from the front of a
2076-92F expansion enclosure.
About this task
The expansion enclosure has a 4U front fascia that covers the display panel and a 1U fascia that covers
the power supply units (PSUs). As Figure 84 on page 74
shows, the fascias are independent; you can
remove or replace one without having to remove or replace the other.
Figure 84. Fascia components on the expansion enclosure
Procedure
1. Use the slide rails to pull the enclosure out of the rack, as described in âRemoving an expansion
enclosure from a rack: 2076-92F â on page 83.
Ensure that a mechanical lift is available to support the weight of the enclosure.
Remove the front (4U) fascia
2. Remove the front fascia by removing the two screws that attach the fascia to the flange on each side of
the chassis, as shown in Figure 85 on page 75.
74
Storwize V7000 : Gen3 Quick Installation Guide for MTM 2076-724, 2076-U7B, 2076-12F, 2076-24F, and
2076-92F
To Next Page
Loading...
