EasyManua.ls Logo

IBM System Storage TS3310 - Step 5: Enter License Keys

IBM System Storage TS3310
275 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
v Subnet Mask - the IP address of the subnetwork
7.
Touch Apply to save the network settings.
8. After a successful save, touch Close.
9. Touch Local to complete configuring your library using the Operator Panel.
Note: The Setup Wizard is not available from the Web User Interface.
Step 5: Enter License Keys
Read “Applying a License Key” on page 4-5 before beginning this step.
If you purchased a Control Path Failover License Key (Feature Code 1682 which
includes Control Path Failover and Data Path Failover) with your 5U or 14U
library or a Capacity Expansion License Key (Feature Code 1640) with your 14U
library, enter those license keys now.
Note: A Data Path Failover license key (Feature Code 1682) is entered at the host.
Refer to the device driver documentation shipped with your library and the
installation instructions shipped with your license keys for more
information.
Touch No if you would like to continue configuring your library without entering
a license key.
To enter a license key:
1. Locate the license key labels.
2. Touch Yes.
3. Touch the License Key text field to access the alphanumeric keyboards.
4. Use the alphanumeric keyboards to enter the key.
5. Touch Apply.
6. Touch Close to continue.
7. Verify that your library has the correct number of licensed slots by selecting
the Home icon (
1
in Figure 5-1 on page 5-2) to view the Capacity View
screen.
8. Place a license key label on the cover plate located on the rear of the library to
the right of the Library Control Blade.
9. Place another license key label on the Appendix D, “Library Configuration
Form,” on page D-1 for safe keeping.
10. Repeat this procedure for each license key.
Step 6: Assign Cleaning Cartridge Slots
Read “Cleaning Slots Configuration” on page 4-1 before beginning this step.
One cleaning cartridge slot is assigned as a default in the library. A maximum of
four cleaning cartridge slots are allowed in the library. If you do not wish to assign
additional cleaning cartridge slots, touch No to continue configuring your library.
To assign additional cleaning cartridge slots:
1. Touch Yes.
6-4 TS3310 Tape Library Setup and Operator Guide

Table of Contents

Related product manuals