1
Handle
3
Power cord receptacle
2
Thumb screws
4
Power switch
Removing a Primary Power Supply
1. Perform “Preparing a Library or Library Module for Repairs” on page 11-2.
2. Unplug each end of the power cord in the proper sequence.
Attention: First, disconnect the power cord from the power source. Then,
disconnect the power cord from the power supply receptacle (
3
in
Figure 11-2).
3. Loosen the two thumb screws (
2
in Figure 11-2) by turning them
counterclockwise.
4. Grasp the handle (
1
in Figure 11-2) and slowly pull the power supply toward
you, while supporting it from underneath.
5. Install a metal cover plate over the vacant power supply slot if you are not
immediately installing a replacement.
Replacing a Primary Power Supply
1. Grasp the handle (
1
in Figure 11-2) while supporting the power supply from
underneath. Then, line up the power supply with the guides in the slot, and
carefully push the power supply into the library.
2. Tighten the two thumb screws (
2
in Figure 11-2) by turning them clockwise.
a66mi022
4
2
1
3
Figure 11-2. Power Supply
11-4 TS3310 Tape Library Setup and Operator Guide
To Next Page
Loading...
