1. Collapse the rail (
9
in Figure 3-3 on page 3-5).
2. Put a centering nut on each rail stud (two studs on the front edge of each rail;
two studs on the back edge of each rail) and finger-tighten (The flat side of the
centering nut should be against the flange of the rail when properly installed.).
v Use the round hole centering nuts (
1
in Figure 3-3 on page 3-5) for vertical
rack rails with round holes.
v Use the square hole centering nuts (
2
in Figure 3-3 on page 3-5) for vertical
rack rails with square holes.
3.
From the front of the rack:
a. Position the rail to the applicable side (right or left) and insert the rail studs
through the marked holes in the vertical rack rail.
Note:
The small shelf portion of the left rail should be positioned to the
right side of the rail. The small shelf portion of the right rail should
be positioned to the left side of the rail. Positioning the rails in this
way will form the shelf on which the library will be installed.
b. Place a thumb nut (
5
in Figure 3-3 on page 3-5) on each stud and tighten.
4. From the back of the rack:
a. Extend the rail and insert the rail studs through the marked holes in the
vertical rack rail.
b. Place a thumb nut (
5
in Figure 3-3 on page 3-5) on each stud and tighten.
5. From the front of the rack, visually verify that the rail is aligned properly with
the rack. You should see thumb screw holes in the following locations:
v Top hole of the first EIA (see Figure 3-4 on page 3-7)
a66ug020
Figure 3-7. Rails installed in rack (rear view)
3-10 TS3310 Tape Library Setup and Operator Guide
To Next Page
Loading...
Need help?
General