1. Replace the power supply component by sliding it into the power supply slot.
First, grasp the handle (
1
in Figure 3-14) while supporting the power supply
component from underneath. Then, line up the power supply component with
the guides in the power supply slot, and carefully push it into the library.
2. Tighten the two thumb screws (
2
in Figure 3-14) on the power supply
component by turning them clockwise.
3. Repeat this procedure for each library power supply.
Step 4: Cabling the Library
At this point in the installation procedure, you install the module-to-module
communication cable, the module communication terminators, the
customer-supplied Ethernet cable, the drive sled cables, and the power supply
cabling. Select and perform one of the following cabling procedures, depending
upon your library configuration:
v “Cabling a 5U Library Containing Fibre Drives”
v “Cabling a 5U Library Containing SCSI Drives” on page 3-17
v “Cabling a 14U Library Containing Fibre Drives” on page 3-19
v “Cabling a 14U Library Containing SCSI Drives” on page 3-20
v “Cabling a Library Containing Fibre and SCSI Drives” on page 3-21
Cabling a 5U Library Containing Fibre Drives
To cable a 5U library (control module) with fibre drives, complete the following
steps:
a66mi022
4
2
1
3
Figure 3-14. Control Module Power Supply
3-16 TS3310 Tape Library Setup and Operator Guide
To Next Page
Loading...
