3. Install a module communication terminator in the lower receptacle of the lower
module of your library (
1
in Figure 3-17 on page 3-19).
4. Install one end of the customer-supplied Ethernet cable (
3
in Figure 3-17 on
page 3-19) in the Library Control Blade Ethernet port, then connect the other
end of the cable to your network.
5. Install one end of the drive fibre cable (
7
in Figure 3-17 on page 3-19) in a
fibre drive in the library, then connect the other end of the cable to your
network. Repeat this for every fibre drive in your library.
6. Install one end of the power cord (
5
and
6
in Figure 3-17 on page 3-19) in
the receptacle in a power supply in your library, then connect the other end of
the cord to your power source. Repeat this for every power supply in your
library.
7. Continue with “Step 5: Powering ON the Library” on page 3-22.
Cabling a 14U Library Containing SCSI Drives
To cable a 14U library (control module + 9U expansion module) with SCSI drives,
complete the following steps:
1
Module communication
terminator
6
SCSI drive-to-host cable
2
Module-to-module
communication cable
7
Power cord (upper module)
3
Ethernet cable (customer
supplied)
8
Power cord (lower module)
1
2
3
4
5
6
7
8
9
a66ug022
Figure 3-18. Cabling of a 14U library containing multiple SCSI drives
3-20 TS3310 Tape Library Setup and Operator Guide
To Next Page
Loading...
