IBM System Storage TS3310 - Cabling a 5 U Library Containing SCSI Drives; Cabling of a 5 U Library with Fibre Drives

1
Module communication
terminator
4
Power cord
2
Ethernet cable (customer
supplied)
5
Fibre drive cable
3
Module communication
terminator
1. Install the upper module communication terminator (
3
in Figure 3-15).
2. Install the lower module communication terminator (
1
in Figure 3-15).
3. Install one end of the customer-supplied Ethernet cable (
2
in Figure 3-15) in
the Library Control Blade Ethernet port, then connect the other end of the cable
to your network.
4. Install one end of the drive fibre cable (
5
in Figure 3-15) in a fibre drive in the
library, then connect the other end of the cable to your network. Repeat this for
every fibre drive in your library.
5. Install one end of the power cord (
4
in Figure 3-15) in the receptacle in a
power supply in your library, then connect the other end of the cord to your
power source. Repeat this for every power supply in your library.
6. Continue with “Step 5: Powering ON the Library” on page 3-22.
Cabling a 5U Library Containing SCSI Drives
To cable a 5U library (control module) with SCSI drives, complete the following
steps:
1
2
3
4
5
a66ug023
Figure 3-15. Cabling of a 5U library with fibre drives
Chapter 3. Installing the Library 3-17