Removing a Drive Sled
Important: Make note of each drive position and associated drive serial number
(S/N) in each unit of the library on the Appendix D, “Library
Configuration Form,” on page D-1. This information will be important
when repopulating the library with the drive(s).
For each drive installed in the library:
1. Loosen the two thumb screws (
2
in Figure 3-9) that hold the drive sled in
place by turning them counterclockwise.
2. To remove the drive sled, grasp the handle (
5
in Figure 3-9) and slowly pull it
toward you, while supporting the drive sled from underneath.
Placing the Library in the Rack
v To place a 5U library (control module) in a rack:
1. With a person on each side, lift the library and slide it onto the rail shelves
in the rack until the library is flush with the flange on the rear of each Rack
Mount Kit rail.
2. Install and tighten rear thumb screws located on the flange on the rear of
each Rack Mount Kit rail.
v To place a 14U library (control module + 9U expansion module) in a rack:
1. With a person on each side lifting the library using the sling and one person
holding the front of the library, slide it partially onto the rail shelves in the
rack.
a66mi023
2
3
4
5
1
Figure 3-9. SCSI Drive Sled (detail)
3-12 TS3310 Tape Library Setup and Operator Guide
To Next Page
Loading...
