v From the Operator Panel, select Operations → Change Drive Mode
v From the Web User Interface, select Manage Drives → Change State of
Drives
Note:
The library can use the drive immediately after the library
application code has been downloaded.
e. Verify the drive’s firmware level by selecting Tools → Drive Info from the
Operator Panel. If the drive does not have the appropriate firmware level,
update it (see “Updating Drive Firmware” on page 7-11.
Removing a Drive Sled
Important: If removing more than one drive sled at a time, record the locations of
each drive before they are removed. Ensure that the drives are
reinstalled in the correct location.
1. Vary all drives offline from the host.
v From the Operator Panel, select Operations → Change Drive Mode.
v From the Web User Interface, select Manage Drives → Change State of
Drives.
2. Disconnect the drive cable and place it on a flat surface in a secure location to
avoid damaging the cable.
a66mi023
2
3
4
5
1
Figure 11-6. Drive sled (detail)
Chapter 11. Add, Remove, Replace Procedures 11-9
To Next Page
Loading...
