Note: If the operator panel does not initialize, check all cable connections, and
ensure that all doors are tightly closed and all power supply switches are
in the ON position. Then, repeat steps 1 and 2.
4. When initialization is complete, configure the library.
Step 6: Configuring the Library
Now it is time to configure the library using the Setup Wizard. Read the
information in Chapter 4, “Configuration Planning,” on page 4-1 and Chapter 5,
“User Interfaces,” on page 5-1 before proceeding to Chapter 6, “Configuring the
Library,” on page 6-1.
Chapter 3. Installing the Library 3-23
To Next Page
Loading...
