1
Installed drive
2
Available drive slot
3
Drive slot guide rails
a. Insert the new drive sled into the empty drive slot. Use the guide rails on
both the drive sled and in the drive slot (
3
in Figure 11-4), slowly slide the
drive sled into the slot. The drive sled must be level to slide in smoothly.
b. When the drive sled is in place (
1
in Figure 11-5 on page 11-8), tighten the
thumb screws (
2
in Figure 11-5 on page 11-8) by turning them clockwise
to secure the drive to the module.
5. Put the library back online.
a66ug049
3
1
2
Figure 11-4. Control module with one SCSI drive installed and one open drive slot with cover plate removed
Chapter 11. Add, Remove, Replace Procedures 11-7
To Next Page
Loading...
