IBM System Storage TS3310 - Page 48

Table 2-3. Valid Loop IDs and their associated AL_PAs for Ultrium Tape Drives in the library (continued)
7-bit Loop ID
(decimal)
8-bit AL_PA
(hexadecimal)
7-bit Loop ID
(decimal)
8-bit AL_PA
(hexadecimal)
7-bit Loop ID
(decimal)
8-bit AL_PA
(hexadecimal)
14 X’D1’ 57 X’7C’ 100 X’34’
15 X’CE’ 58 X’7A’ 101 X’33’
16 X’CD’ 59 X’79’ 102 X’32’
17 X’CC’ 60 X’76’ 103 X’31’
18 X’CB’ 61 X’75’ 104 X’2E’
19 X’CA’ 62 X’74’ 105 X’2D’
20 X’C9’ 63 X’73’ 106 X’2C’
21 X’C7’ 64 X’72’ 107 X’2B’
22 X’C6’ 65 X’71’ 108 X’2A’
23 X’C5’ 66 X’6E’ 109 X’29’
24 X’C3’ 67 X’6D’ 110 X’27’
25 X’BC’ 68 X’6C’ 111 X’26’
26 X’BA’ 69 X’6B’ 112 X’25’
27 X’B9’ 70 X’6A’ 113 X’23’
28 X’B6’ 71 X’69’ 114 X’1F’
29 X’B5’ 72 X’67’ 115 X’1E’
30 X’B4’ 73 X’66’ 116 X’1D’
31 X’B3’ 74 X’65’ 117 X’1B’
32 X’B2’ 75 X’63’ 118 X’18’
33 X’B1’ 76 X’5C’ 119 X’17’
34 X’AE’ 77 X’5A’ 120 X’10’
35 X’AD’ 78 X’59’ 121 X’0F’
36 X’AC’ 79 X’56’ 122 X’08’
37 X’AB’ 80 X’55’ 123 X’04’
38 X’AA’ 81 X’54’ 124 X’02’
39 X’A9’ 82 X’53’ 125 X’01’
40 X’A7’ 83 X’52’ 126 X’00’
41 X’A6’ 84 X’51’ 127
42 X’A5’ 85 X’4E’
Supported Topologies
The Ultrium 3 Tape Drive can be attached in a two-node configuration, either
directly to a switch as a public device (switched fabric) or directly to a host bus
adapter (HBA) as a private device. It can connect as a public device in a switched
fabric topology (through an F_port) or connect using Arbitrated Loop topology
(through an L_port or FL_port).
The Ultrium 3 tape drive automatically configures to an L_port or an N_port when
it boots. The type of port to which it configures depends on whether the drive
recognizes the connection as a loop or a point-to-point connection:
v An L_Port supports a Fibre Channel Arbitrated Loop connection to an NL_port
or an FL_port.
2-6 TS3310 Tape Library Setup and Operator Guide