Note: Make sure that the library is connected to the network before modifying
network settings.
To modify network settings, you need to provide the data for the following fields:
v Library Name is the network name you want to assign to the library. The library
name can be up to a maximum of twelve characters long.
v Dynamic Host Configuration Protocol (DHCP) setting defaults to enabled.
Setting the library to enable triggers via DHCP to automatically configure the
library network settings. ″Enable″ makes the IP Address, Subnet Mask, and
Default Gateway text boxes unavailable. ″Disable″ makes the IP Address,
Subnet Mask, and Default Gateway text boxes available for you to manually
set the library network settings.
v IP Address is the IP Address of the library. This text box is available only if
DHCP is disabled.
v Default Gateway is the IP Address of the default gateway for your portion of
the Ethernet network. This text box is available only if DHCP is disabled.
v Subnet Mask text box is available only if DHCP is disabled.
Chapter 4. Configuration Planning 4-7
To Next Page
Loading...
Need help?
General
