CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
– Throw or immerse into water
– Heat to more than 100°C (212°F)
– Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To remove the system-board battery, complete the following steps:
Procedure
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 32.
2. Follow any special handling and installation instructions that come with the
battery.
3. Turn off the server (see “Turning off the server” on page 22) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
4. Remove the server top cover (see “Removing the server top cover” on page
258).
5. Remove the PCI riser-card assembly (see “Removing a PCI riser-card assembly”
on page 206).
6. Locate the battery on the system board.
210 System x3650 M4 BD Type 5466: Installation and Service Guide
To Next Page
Loading...
Need help?
General