S.2018001 [S.2018001] An Uncorrected PCIe Error has Occurred at Bus % Device % Function %. The Vendor ID
for the device is % and the Device ID is %.
Explanation: PCIe Uncorrected Error Detected
Severity: Error
User response: Complete the following steps:
1. If this node and/or any attached cables were recently installed, moved, serviced or upgraded, a. Reseat Adapter
and any attached cables. b. Reload the latest Device Driver c. If device is not recognized, reconfiguring slot to
Gen1 or Gen2 may be required. Gen1/Gen2 settings can be configured via F1 Setup -> System Settings -> Devices
and I/O Ports -> PCIe Gen1/Gen2/Gen3 Speed Selection, or the ASU Utility.
2. Check IBM support site for an applicable device driver, firmware update, version of service information for this
product or other information that applies to this error. Load new device driver and any required firmware
updates.
3. If problem persists, then remove Adapter Card. If system reboots successfully without the adapter, replace that
card.
4. Trained Service technician only) Replace the processor.
5. (Trained Service technician only) Replace the system board.
S.3020007 [S.3020007] A firmware fault has been detected in the UEFI image.
Explanation: Internal UEFI Firmware Fault Detected, System halted
Severity: Error
User response: Complete the following steps:
1. Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
2. Reflash UEFI image.
3. (Trained service technician only) Replace the system board.
S.3028002 [S.3028002] Boot permission timeout detected.
Explanation: Boot Permission Negotiation Timeout
Severity: Error
User response: Complete the following steps:
1. Check IMM logs for communication errors and resolve.
2. Reseat system
3. If problem persists escalate to the next level of support
S.2018001 • S.3028002
Appendix B. UEFI/POST error codes 599
To Next Page
Loading...
Need help?
General
