Replacing the top cover
Use this information to replace the server top cover.
About this task
To replace the server top cover, complete the following steps:
Procedure
1. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
Important: Before you slide the top cover forward, make sure that all the tabs
and the pins on the top and side of the top cover engage the chassis correctly.
2. Place the cover-release latch in the open (up) position.
3. Position the top cover on top of the server.
4. Insert the bottom tabs of the top cover into the matching slots in the server
chassis.
5. Press down on the cover-release latch to slide the cover forward and lock the
cover in place.
6. Slide the server into the rack.
7. Reconnect the external cables and power cords.
2
1
Cover-release latch
Figure 69. Top cover installation
Chapter 5. Removing and replacing components 147
To Next Page
Loading...
