Replacing the media cage
Use this information to replace the media cage.
About this task
To install the media cage, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 283.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the top cover (see “Removing the top cover” on page 146).
4. Carefully slide the media cage into the server.
5. Tighten the thumbscrew to secure the media cage onto the server.
6. Reconnect the USB, CD/DVD and operator information/LCD panel cables to
the system board first; then, route the cables as the following illustration.
Remember to insert the cables into the cable clip for proper routing.
Media cage
Figure 103. Media cage installation
Thumbscrew
Figure 104. Thumbscrew
178 System x3650 M5 Type 5462: Installation and Service Guide
To Next Page
Loading...
